Will the antenna feeder lightning arrester affect signal attenuation?

The interfaces of the KILOAMP antenna feeder lightning arrester are all matched with the equipment interfaces. High-quality connectors are all selected, and the insertion loss is all less than 0.5dB. Therefore, the signal attenuation can almost be ignored.

What are the precautions for the selection of antenna feed lightning arresters?

The selection of antenna feeder lightning arresters mainly needs to consider aspects such as interface type, voltage, transmission rate, and center frequency. Only when these parameters are matched can the communication of the equipment be guaranteed not to be affected. The current capacity Imax of antenna feeder lightning arresters is generally 10-20kA and is widely used in communication base stations and other scenarios.

What are the common connectors of the antenna feeder lightning arrester?

The common connectors of the antenna feeder lightning arrester include N/DIN/SMA/SMB/UHF connectors, etc. At the same time, it is necessary to distinguish between male and female connectors before connection.

Does the antenna feeder lightning arrester need power supply?

The antenna feeder lightning arrester is passive and does not require power supply. Its internal protection is mainly achieved through components such as gas discharge tubes (GDT).

Products

RF Arrester

The RF line is the connection between the antenna and the communication equipment. As the antenna is located outdoors and at a relatively high position, it is prone to accumulation. Therefore, it is very necessary to protect the RF port of the communication equipment. When selecting the type, attention should be paid to the matching of the connector, frequency and other aspects. The conventional feedline lightning arrester of KILOAMP covers about ten connectors such as N and L16. The frequency range covers between 0 and 6G.

Types of RF Arrester

01- N-Type RF Arrester
MORE

Features of RF Arrester

01

1

Rich interfaces, different interfaces can be selected according to the type of antenna connector;
02

2

Signal attenuation is reduced. The cavity and core wire of the SPD connector are made of high-quality copper materials, with optimal signal attenuation and standing wave ratio performance;
03

3

It has a large flow capacity, uses high-quality GDT internally, has fast surge absorption and strong protection capabilities.

RF Arrester FAQs

Will the antenna feeder lightning arrester affect signal attenuation?

The interfaces of the KILOAMP antenna feeder lightning arrester are all matched with the equipment interfaces. High-quality connectors are all selected, and the insertion loss is all less than 0.5dB. Therefore, the signal attenuation can almost be ignored.
What are the precautions for the selection of antenna feed lightning arresters?

The selection of antenna feeder lightning arresters mainly needs to consider aspects such as interface type, voltage, transmission rate, and center frequency. Only when these parameters are matched can the communication of the equipment be guaranteed not to be affected. The current capacity Imax of antenna feeder lightning arresters is generally 10-20kA and is widely used in communication base stations and other scenarios.
What are the common connectors of the antenna feeder lightning arrester?

The common connectors of the antenna feeder lightning arrester include N/DIN/SMA/SMB/UHF connectors, etc. At the same time, it is necessary to distinguish between male and female connectors before connection.
Does the antenna feeder lightning arrester need power supply?

The antenna feeder lightning arrester is passive and does not require power supply. Its internal protection is mainly achieved through components such as gas discharge tubes (GDT).